Electronic Board Ultrasonic Machine Electronic Assembly Cleaning

38L 40KHZ Electronic Assembly Cleaning Electronic Board Ultrasonic Machine
How an ultrasonic cleaner works to clean Medical Device
special solvents designed for cleaning Electronic Board can be utilized however very good results can also be obtained by using water and an environment friendly low pH cleaning agent. Low pH or excessively high pH chemicals should be avoided. These aggressive chemistries in combination with heat and the ultrasonic activity can potentially cause damage to delicate pieces.
In the cleaning process, Electronic Board are submerged in the cleaning solvent. The intensity of the cleaner as well as the heat of the solution should be adjusted to successfully engage the application. Ultrasonic cleaners work quickly to completely remove dirt and other contamination through a cavitation process.
Electronic Board is cleaned in the same way as other items. Electronic Board are submerged into a gentle solvent and the cleaning process sends ultrasonic waves through the solution which creates bubbles that clear away all dirt and grime clinging to the jewelry’s surface. In most cases a short two to three minute cleaning is all that is required for optimum results.

Benefits of cleaning Electronic Board with an ultrasonic cleaner
• The process reaches parts of the Medical Device that are extremely difficult to clean with traditional cleaning methods.
Medical Device gets completely clean, leaving it looking brand new.
• No need to disassemble the jewelry.
• Multiple pieces can be cleaned at once, saving time and money. Follow manufacturer recommendations for maximum pieces in your ultrasonic cleaner.
• Gentle cleaning does not damage delicate pieces and allows for cleaning as often as necessary.

Steps to cleaning Electronic Board with an ultrasonic cleaner
1. Fill chamber with cleaning solvent
2. Note that water must be hot. Ideally, you would use an ultrasonic cleaner with a heater.
3. Run a pre-cleaning cycle
4. Submerge Medical Device into cleaning solvent
5. Run the cleaning cycle
6. After the cycle is complete, remove the items from the parts basket and rinse the solution from the items
7. After rinsing brush the pieces with a soft-bristled brush. Paying special attention to brushing around the claws and crowns that hold the gemstones or diamonds in place.
8. Complete with a final rinse. Place the jewelry in w

 

 

Pls find more specifications below:

Model	T-12S(digital timer&heater, Power adjustable)
Capacity	38liter
Tank size	500×300×250mm (LxWxH)
Unit size	640×440×470cm (LxWxH)
Packaging size	740x540x570mm (wooden case)
Ultrasonic power	240~600W adjustable
Heating power	1500W
Timer	1~99mins adjustable
Heater	20~80C adjustable
Frequency	40,000Hz
Power supply	AC110~130V, AC 220~240V, 50/60 Hz
Tank material	SUS304, 2mm thickness
Shell Material	SUS304, 1mm thickness
Others	With drainage, basket, lid
N.W./ G.W.	51KG/ 72KG
Warranty	1 year& tech support for life